Hartan Racer GT Instructions page 10

WARNING!
When opening out and folding down the frame and when adjusting the back­rest,
pinch­points may be caused in which fingers etc. can be trapped unless care is exercised. Ensure that
your child has plenty of clearance space.
Unfolding the pram
By pushing the lock buttons 4, unfold the upper section to bring the handle in horizontal position. Pull handle
1 upwards until handle catch 2 has engag ed.
WARNING!
Before using the pram, make sure all catches are locked.
Folding the pram
Turn safety turn­lock 3 inward until the handle's catch 1 has released. Push handle downwards to fold the
pram. By pushing the lock buttons 4, fold the handle's upper section inward.
Height adjustment of handlebar
Press the two handle­folding lock buttons 4 to bring the upper section of the handlebar 1 in the desired
position.
Removing the wheels
Release the parking brake 7. To remove or replace the wheels, press button 5. If replacing the wheel, make
sure that it is correctly latched into place.
Lock-type-swivel wheels
Turn the cap 6 so that the red point is visible to pre­select the straight­line motion mode, which will be
activated the moment the wheels point in forward direction. Turn the cap 6 so that the green point is visible
to release the swivel lock. To remove, press the button in the centre of the cap 6 and withdraw the wheel
from its seating. To fix the wheel in place, push the wheel with its fixing pin into the seating until it audibly
clicks into place.
Sun canopy
The sun shade can be folded down or removed using the zipper.
Adjust the handbrake (optional)
Readjust the hand brake by means of the cable adjusting barrel 9 (above).
A different brake effect on the two rear wheels can be corrected by means
of the cable adjusting barrel 9a (below).
Adjustable suspension system
By turning the selector 8, a „hard" or „soft" position can be selected for
suspension.
Parking brake
Push the red brake button 7 to engage the brake. Having parked the pram,
try to push it to check thebrake. Push the green brake button 7 to release
the brake.
WARNING!
Make sure the brake is always closed when placing
the baby in the carriage or taking it out of it.
Hood and safety bar
By pressing the bayonet joint 12, the hood or the safety bar can be
pulled out. When inserting it, make sure the safety bar locks into
place correctly and be careful not to pinch any of the fabric parts.
By pressing the buttons, the safety bar position can be changed.
WARNING!
The hood bar of the stroller and the safety bar are
not suitable for carrying the pram.
Instructions
9a 8 7 8 9a
9