Machine Identification; Important - PEUGEOT ENERGYSAW-254A Manuel D'utilisation

1. Dust Bag
2. Locking knob for head slide rails
3. Locking knob for saw head
4.Bevel locking handle at the rear of the table
5. Vice
6. Side extension
7. Upper rail
9. Laser
10. Scale
11. Bevel indicator for mitre cuts
Make sure that the saw is switched off and disconnected from the power source before any assembly or adjustment operations.
wORKING Of THE CUTTING ARM
1.Slightly press the cutting arm down and keep it down.
2.Pull out the knob (3) as shown in Figure A.
3.Raise the cutting arm to the up position.
To lock down the cutting arm, proceed as follows:
1.Push and hold the locking knob (3).
2.Lower the cutting arm.
3.Push the locking knob (3) back into its original position.
All manuals and user guides at all-guides.com

MACHINE IDENTIfICATION

ASSEMBLy

IMPORTANT!

Extension adjustment
screw
12. Lever for setting main angles
13. Locking handle
14. Cross cut gauge
15. Blade guard
16. Motor
17. On/off switch
18. Switch locking button
19.Laser switch
20. Guide Fence
17