Installing The Footrests; Installing The Headrest - Invacare Aquatec Ocean VIP Ergo Manuel D'utilisation

4.2.6 Installing the footrests

1. Insert the pin of the clip G from the outside into the
required hole on the footrest B. Make sure the clip
engages around the tube.
2. Push the footrest into the guide H at the front of the
side part until the pin of clip G engages in the groove
A. The footrest can no longer be turned to the side.
The assembly procedure is the same for the right
and the left footrest.
Adjusting the height of the footrests
The footrests can be shortened if required (refer to
the service manual). Shortening the footrests must
be performed by a qualified technician.
1639504-C
All manuals and user guides at all-guides.com
1. Slightly pull up the footrest B.
2. Pull the clip G out of the hole in the footrest and
re-insert it into the required hole. Pull out the footrest
slightly further if necessary.
3. Push down the footrest until the groove A catches the
pin of the clip.
4. Set the other footrest to the required height as
described.
Adjusting the inclination of the foot plates
The inclination of the foot plates can be adjusted
infinitely variably.
1. Loosen the Allen screw C on the foot plate using a size
4 Allen key.
2. Turn the foot plate D to the required position.
3. Re-tighten the Allen screw.

4.2.7 Installing the headrest

Setup
15