Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Keyed chuck (fig. D)
•
Open the chuck by turning the sleeve (12)
anti-clockwise.
•
Insert the bit shaft (13) into the chuck.
•
Insert the chuck key (14) into each hole (15) in the side
of the chuck and turn clockwise until tight.
Use
Warning! Let the tool work at its own pace. Do not overload.
Warning! Before drilling into walls, floors or ceilings, check
for the location of wiring and pipes.
Warning! Do not apply chisels when the tool is in the drilling
mode.
Selecting the operating mode (fig. F)
The tool can be used in three operating modes.
•
To operate the drilling mode selector (3), rotate it
towards the required position, as indicated by the
symbols.
•
To operate the operating mode selector (4), push the
unlock button (16) and rotate the selector towards the
required position, as indicated by the symbols.
Drilling
•
For drilling in steel, wood and plastics, and for
screwdriving set the operating mode selector (4) to the
position and the drilling mode selector (3) to the
position.
Hammer drilling
•
For hammer drilling in masonry and concrete, set the
operating mode selector (4) to the
drilling mode selector (3) to the
hammering, the tool should not bounce and run
smoothly. If necessary, increase the speed.
Hammering
•
For hammering with spindle lock, and for light chiselling
and chipping, set the operating mode selector (4) to the
•
When changing from hammer drilling to chiselling, turn
the chisel to the desired position. If resistance is felt
during mode change, slightly turn the chisel to engage
the spindle lock.
Switching on and off
•
Select the required speed by turning the speed selector
dial (2).
•
To switch the tool on, press the on/off switch (1).
•
To switch the tool off, release the on/off switch.
Brush monitor (fig. E)
Your tool has a built in system that monitors the health of the
brushes.
•
Green brush monitor indicator (17). The brushes are in
good condition.
•
Red brush monitor indicator (18). The brushes are warn
and need replacing, return your tool to an authorised
Black & Decker Service Centre in order to to have the
brushes replaced.
Accessories
The performance of your tool depends on the accessory
used. Black & Decker and Piranha accessories are
engineered to high quality standards and designed to
enhance the performance of your tool. By using these
accessories you will get the very best from your tool.
position and the
position. When
position and the drilling mode selector (3) to the
position.
ENGLISH
7
Publicité
Table des Matières
