Electric Lift Bed Operation; Tail Gate Operation - Cushman HAULER 1200X 2012 Manuel De L'utilisateur

OPERATING PROCEDURES
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.

ELECTRIC LIFT BED OPERATION

Exercise caution while operating the electric lift bed to ensure clothing is not caught during lifting or
lowering procedure. Severe injury could result if bed is lowered and traps fingers or other body
parts.
4
The electric lift switch is located on the driver side of the front seat panel. Move the toggle switch lever up to raise the
load bed and down to lower.
Before operating load bed, check to ensure no one is behind the vehicle.
Electrical Bed Latch

TAIL GATE OPERATION

To open the tail gate, lift tail gate straight up with a sharp upward pull to lift out of the closed position and pivot out for
open position. To remove the tail gate, remove the side cables from the load bed and open tail gate until it is straight
down, move tail gate panel straight up to remove from pins and remove from the load bed. Reassemble in reverse
order.
Gas Strut with Tether Cable
Never fill a gas can in the bed of a vehicle. Static discharge could ignite gasoline vapor and cause
an explosion.
Always place a gas can on the ground before filling. Never fill a gas can in the bed of the vehicle. Static electricity is
built up during the fueling process and could discharge causing the gasoline vapor to ignite.
4 - 15