EN
34
BATTERY
Battery protection
•
When the battery is powered mode, standby operation is invalid.
•
When the battery is low, the system prompts "LOW POWER", and the
POWER lamp blinks.
•
When the battery is serious shortage, the system prompts "NO
POWER", POWER lamp blinks .
•
After 1 minute, the system will stop.
•
And the control panel has a red lamp, when the battery is enough, the
lamp is normally turn on .
•
When the battery has enough charge, the control panel will light up
normally
Battery removal
1. Remove the screws on the rear panel.
2. Take out the battery.
3. Disconnect
Warning: Danger of chemical burns
Do not open the battery.
1
2
3