Usage Precautions - Panasonic WX-SR202DNP Mode D'emploi

Usage precautions

Other than the aforementioned "Precautions", make sure to follow the points below.
This product is a professional equipment
This product is intended for indoor use only
● It cannot be used outdoors.
Avoid exposing the product to direct sunlight for extended periods of time, and do not
install it near air conditioners or heaters. Failing to do so may lead to damage to the
shape and color of the product, and may cause it to malfunction. Also avoid exposure to
water droplets and bubbles.
Use this product with care
● This product contains delicate components which may be damaged by improper use or
storage.
● Repair or replace any damaged components.
The operating temperature range is
● Between 0 °C (32 °F) and 45 °C (113 °F). Using the product outside of this range may
cause it to malfunction or to be damaged.
The power switch
● Turning the [POWER] switch to the OFF position will turn the receiver OFF, but it will not
interrupt the flow of current. (The [POWER] indicator being off does not necessarily
mean that there is no power going through the receiver.) Remove the power cord from
the power outlet to completely break off the flow of current to the receiver.
Power
● The receiver uses AC 120 V (60 Hz) power. Connect the receiver to an enough capacity
power source.
● Connect the power cord to the power source in one of the following ways.
• Install the receiver near the electric outlet, allowing for easy access to the power plug.
• Connect it to a breaker panel with at least 3.0 mm (1/8 inches) of space between
contacts. Use a breaker which can cut off power from all poles except the protective
ground connection.
Microphone remaining battery level indication
● When the distance between the microphone and the antenna is too far, the signal
reception becomes unstable so that microphone remaining battery level may not be
obtained. Keep the proper distance to ensure a stable wireless connection when using
the remaining battery level indication function. Also read "Antenna field selection" (page
44) about the distance (wireless reach) between the microphone and the antenna.
When turning the power switch to ON or OFF
● All connected peripheral devices and power amplifiers have to be turned OFF before the
power switch operation. Failing to do so may cause a clicking noise which could
potentially damage the speakers or other peripheral devices.
PUQX1039ZAV1_WX-SR202DNP_OI_en-fr.indb 15
15
2022/04/27 13:17:37