Panasonic WX-SR202DNP Mode D'emploi page 21

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

r W ireless antenna connectors [ANTENNA 1/2/3/4/5/6/7/8]
Ports used to connect the wireless antennas to the receiver.
Use LAN cables to connect the antennas. The antenna connected to [ANTENNA 1] will
be used as the reference antenna for wireless synchronization. (page 42)
s D ante Network Primary connector [PRIMARY]
Ports (RJ45) used to connect to Dante devices with LAN cables.
Connect to the primary line in Dante network when there is a redundancy network.
Audio is output as follows from the product to the Dante network:
Audio from each channel of the product;
Mixed audio from all of the product's channels and the audio input to the [AUDIO IN]
connector.
t D ante Network Secondary connector [SECONDARY]
Ports (RJ45) used to connect to Dante devices with LAN cables.
Important
Connect to the secondary line in Dante network when there is a redundancy network.
Audio is output as follows from the product to the Dante network:
Audio from each channel of the product;
Mixed audio from all of the product's channels and the audio input to the [AUDIO IN]
connector.
● The phase of Mix-output to the Dante network is inverted (both Primary
and Secondary).
u N etwork status indicator [LINK/ACT]
Shows the link status of the Dante network.
On (green)
: Network link established
Blinking (green) : Network link active
Off
: No link with the Dante network
v N etwork speed indicator [1G]
Shows the speed of the Dante network.
On (yellow)
: 1 Gbps
Off
: 10/100 Mbps
w E xternal input connector [AUDIO IN -10 dBV 600 Ω]
Inputs audio from external devices, mixes it and outputs it to the mix output connector
and Dante audio network.
x M ix output connector [MIX OUT -10 dBV 600 Ω]
Outputs audio obtained by mixing the audio from each channel with the audio from the
[AUDIO IN] connector.
y S IGNAL GND connector [SIGNAL GND]
Gathers the SIGNAL GND from external devices to eliminate electrical potential difference.
z P ower cord
Connect the power cord to an AC 120 V 60 Hz power source.
PUQX1039ZAV1_WX-SR202DNP_OI_en-fr.indb
21
21
2022/04/27
13:17:38

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Wx-sr204dnp

Table des Matières