Panasonic WX-SR202DNP Mode D'emploi page 55

4
Pair the microphone to the receiver
Make sure that the [POWER] indicator on the receiver lights green, then press for at
least two seconds the [REG] button of the channel to which you want to pair a
microphone. Both the microphone and the receiver will enter pairing mode and pairing
will start. During pairing mode, the [PWR] indicator on the microphone and the [REG]
indicator of the channel whose [REG] button has been pressed on the receiver will
blinks orange.
If pairing is completed successfully, the [PWR] indicator on the microphone switches to
the normal status according to the remaining battery level (green, orange, or red), and
the [REG] indicator on the paired channel on the receiver lights green for one second
and then goes off.
● If pairing could not be completed successfully, the [PWR] indicator on the
microphone will blinks red.
Power indicator
Receiver
5
Unplug the microphone from the receiver
Unplug the cables connecting the microphone to the receiver.
If pairing has been completed successfully, the microphone starts transmitting audio.
Important
6
Place the battery cover back onto the microphone
Refer to the microphone manual for further details.
● The [REG] button is invalid if the channel to which microphone is paired and
if that microphone is in use. Turn the currently paired microphone power
OFF, then you can pair a different microphone to the channel that is already
in use.
● When a channel on the receiver is in pairing mode, all other channels can
still be used as normal.
● Paired microphones can be removed from the configuration/maintenance
PC installed the support software. Refer to the support software manual for
further details.
PUQX1039ZAV1_WX-SR202DNP_OI_en-fr.indb
Register indicator
Register button
55
* The illustration shows
WX-SR204DNP.
The switch cover is
removed in this illustration.
55
2022/04/27 13:17:45