Selecting Treble Frequency; Adjusting Loudness; Using Subwoofer Output; Adjusting Subwoofer Settings - Pioneer SUPER TUNER III D DVH-P5000MP Mode D'emploi

Section
11 Audio Adjustments
1 Press A and hold until frequency and
the Q factor (e.g., F- 80:Q1W) appears in
the display.
2 Press A to select B.
Press A until B appears in the display.
3 Press m or n to select the desired
frequency.
Press m or n until the desired frequency
appears in the display.
4063100160 (Hz)

Selecting treble frequency

You can select the treble frequency for level
adjustment.
1 Press A and hold until frequency and
the Q factor (e.g., F- 80:Q1W) appears in
the display.
2 Press A to select T.
Press A until T appears in the display.
3 Press m or n to select the desired
frequency.
Press m or n until the desired frequency
appears in the display.
2k4k6k10k (Hz)

Adjusting loudness

Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Press A to select LOUD.
Press A until LOUD appears in the display.
2 Press r to turn loudness on.
Loudness level (e.g., LOUD :MID) appears in
the display.
58
En
3 Press m or n to select a desired
level.
Each press of m or n selects level in the
following order:
LOW (low)MID (mid)HI (high)
4 Press q to turn loudness off.
LOUD :OFF appears in the display.

Using subwoofer output

This unit is equipped with a subwoofer output
which can be turned on or off.
1 Press A to select SUB, W.
Press A until SUB, W appears in the display.
# When the subwoofer controller setting is
P/O :FUL, you cannot select SUB, W.
2 Press r to turn subwoofer output on.
SUB, W:NOR appears in the display. Subwoo-
fer output is now on.
# If the subwoofer output phase has been set to
the reverse, SUB, W:REV will be displayed.
# To turn subwoofer output off, press q.
3 Press m or n to select the phase of
subwoofer output.
Press m to select reverse phase and REV ap-
pears in the display. Press n to select nor-
mal phase and NOR appears in the display.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1 Press A to select 80: 0.
Press A until 80: 0 appears in the display.
# When the subwoofer output is on, you can se-
lect 80: 0.