Selecting Bass Frequency; Selecting Treble Frequency; Adjusting Loudness; Using Subwoofer Output - Pioneer PREMIER DEH-P470MP Mode D'emploi

Section
08 Audio Adjustments
3 Press a or b to adjust the level.
Each press of a or b increases or decreases
the selected bass or treble level. +6  6 is dis-
played as the level is increased or decreased.

Selecting bass frequency

You can select the bass frequency for level ad-
justment.
1 Press AUDIO and hold until frequency
and the Q factor (e.g., F- 80:Q1W) appears
in the display.
2 Press AUDIO to select B.
Press AUDIO until B appears in the display.
3 Press c or d to select the desired fre-
quency.
Press c or d until the desired frequency ap-
pears in the display.
4063100160 (Hz)

Selecting treble frequency

You can select the treble frequency for level
adjustment.
1 Press AUDIO and hold until frequency
and the Q factor (e.g., F- 80:Q1W) appears
in the display.
2 Press AUDIO to select T.
Press AUDIO until T appears in the display.
3 Press c or d to select the desired fre-
quency.
Press c or d until the desired frequency ap-
pears in the display.
2k4k6k10k (Hz)
36
En

Adjusting loudness

Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Press AUDIO to select LOUD.
Press AUDIO until LOUD appears in the dis-
play.
2 Press a to turn loudness on.
Loudness level (e.g., LOUD :MID) appears in
the display.
3 Press c or d to select a desired level.
Each press of c or d selects level in the fol-
lowing order:
LOW (low)MID (mid)HI (high)
4 Press b to turn loudness off.
LOUD :OFF appears in the display.

Using subwoofer output

Turning a subwoofer on/off

This unit is equipped with a subwoofer output
which can be turned on or off.
1 Press AUDIO to select SUB, W.
Press AUDIO until SUB, W appears in the dis-
play.
# You can also select the subwoofer setting
menu by pressing SW on the unit.
# When the subwoofer controller setting is
P/O:FUL, you cannot select SUB, W.
2 Press a to turn subwoofer output on.
Sub W.:NOR appears in the display. Subwoo-
fer output is now on.
# If the subwoofer output phase has been set to
the reverse, Sub W.:REV will be displayed.
# To turn subwoofer output off, press b.