Loading A Disc; Adjusting The Volume; Turning The Unit Off - Pioneer SUPER TUNER III D DVH-P5000MP Mode D'emploi

Basic Operations
can be controlled by this unit. When two exter-
nal units are connected, the allocation of
them to external unit 1 or external unit 2 is
automatically set by this unit.
! When this units blue/white lead is connected
to the cars auto-antenna relay control term-
inal, the cars antenna extends when this
units source is turned on. To retract the an-
tenna, turn the source off. (When you con-
nected a Pioneer multi-channel processor
(DEQ-P7000) to this unit, auto-antenna cannot
be controled.)

Loading a disc

1 Press OPEN to open the front panel.
Disc loading slot appears.
# After a disc has been inserted, press SOURCE
to select the DVD player.
2 Insert a disc into the disc loading slot.
When you set A-PLY: ON, playback will auto-
matically start. If you set A-PLY: OFF, press
SOURCE to select DVD (refer to the previous
page).
Disc loading slot
# To eject a disc, press EJECT.
# To avoid a malfunction, make sure that no
metal object comes into contact with the term-
inals when the front panel is open.
3 Close the front panel.
! The DVD player plays one, standard, 12-cm or
! Do not insert anything other than a disc into
! If you cannot insert a disc completely or if
! If the DVD player does not operate properly,

Adjusting the volume

% Use VOLUME to adjust the sound level.
With the head unit, rotate VOLUME to in-
crease or decrease the volume.
With the remote control, press VOLUME to in-
crease or decrease the volume.

Turning the unit off

% Press SOURCE and hold until the unit
turns off.
EJECT button
When the DVD player is
operated from rear seats
% Press REAR.S to turn the DVD playback
off.
REAR will disappear from the head units dis-
play.
Notes
8-cm (single) disc at a time. Do not use an
adapter when playing 8-cm discs.
the disc loading slot. Discs which can be
played back are listed on Playable discs on
page 7.
after you insert a disc the disc does not play,
check that the label side of the disc is up.
Press EJECT to eject the disc, and check the
disc for damage before inserting the disc
again.
an error message such as ERROR-02 may be
displayed. Refer to Error messages on page
83.
Section
04
17
En