Miscellaneous; Cleaning And Maintenance - Medisana Medistim Mode D'emploi

GB

5 Miscellaneous

5.1
Trouble-
shooting
Please contact your
service centre if it
is not possible to
remedy a fault in the
manner described.
5.2
Cleaning and
maintenance
16
All manuals and user guides at all-guides.com
Fault
LED fails to light up
LED lights up weakly
Low output from device
LED function normal
but no power output
Device switches off
prematurely
Electrodes:
• Clean the adhesive surface after use to achieve better adhesion. Moisten the gel
with a drop of water and allow it to dry briefly. Then stick the electrode back on
the protective film.
• The length of time the electrodes remain usable depends on their storage, skin
type and use. Store the electrodes in their storage box in a cool, dry place.
Device:
• The device does not require any special maintenance.
• Remove the battery before cleaning the device.
• Never use aggressive cleaning products or stiff brushes.
• Clean the device with a soft, possibly slightly moistened cloth. Do not
allow water to penetrate the device. Do not use the device again until it is
completely dry.
• Remove the battery from the device if it is not going to be used for some
time.
• Do not expose the device to direct sunlight and protect it against dirt and
moisture.
• With the electrode pad on the protective plastic film, store the device in a
cool, dry place in the storage box provided on purchase.
Cause
No battery in the device Replace battery
or battery spent
Battery not inserted
correctly
Device not switched on
Insulating film has not
been removed
Battery spent
Electrode pad dirty
Device not applied
properly
Battery spent
Electrode pad dirty or
short-circuited
Battery spent
Electrode pad worn
out or dirty
Device not applied
properly
Remedy
Insert battery again
Switch device on
Remove insulating film
from between battery
and device
Replace battery
Clean /replace electrode
pads
Re-apply device
Replace battery
Check electrode pads
and replace if necessary
Replace battery
Check electrode pads
and replace if necessary
Re-apply device