SOUNDMASTER SCD1990SW Manuel page 13

•
Select a suitable location for the device, such as a dry, flat, non-slip surface on which it is
easy to operate the machine.
•
Ensure that the device is sufficiently ventilated.
•
Remove the protective film from the display if it is still present.
• Press the "STANDBY / FUNCTION" button to turn on the device.
• Press the "STANDBY / FUNCTION" button for approx. 3 seconds to switch into the standby
mode.
Power Supply
•
Ensure that the voltage is the same as that indicated on the model identification plate.
•
Connect the power cable supplied (see battery compartment if necessary) to a properly
installed safety power socket and the mains connector AC on the back of the machine.
Inserting the Batteries (not supplied)
1. Open the lid of the battery compartment.
2. Insert 6 batteries of type UM-2 ("C" size) 1.5 V. Please ensure that the polarity is correct (see
the floor of the battery compartment)!
3. Then close the battery lid.
NOTE:
When a mains cable is connected the batteries are automatically switched off.
After about 10 minute without a signal, the device will automatically switch to standby.
The system must be in standby mode in order to set the clock.
1. Press and hold the "ENTER / PLAY / PAUSE / CLOCK" button for approx.2 seconds.
2. Use the "SKIP+ / TUNING+" & "SKIP- / TUNING-" buttons to set the time format "12 / 24hr".
3. Press the "ENTER / PLAY / PAUSE / CLOCK" button to confirm time format.
4. Use the "SKIP+ / TUNING+" & "SKIP- / TUNING-" buttons to set the hours accordingly. The
hour digits start flashing.
5. Press the "ENTER / PLAY / PAUSE / CLOCK" button to confirm the hour.
6. Repeat step 4 and 5 to set the minute / date.
NOTE:
Press and hold the "ENTER / PLAY / PAUSE / CLOCK" button during operation order to briefly
display the current time.
Setting of the alarm time
The system must be in standby mode in order to set the alarm.
You have the option of setting two alarm times. Proceed as follows:
1. Press the "VOLUME- / ALARM 1" button for about 3 seconds. The hours of the currently set
alarm time will start to flash.
2. Perform the settings with the "SKIP+ / TUNING+" & "SKIP- / TUNING-" buttons.
3. Press the "VOLUME- / ALARM 1" button to confirm. The minutes will start to flash.
4. Perform the settings with "SKIP+ / TUNING+" & "SKIP- / TUNING-" button.
INSTALLATION
SETTING CLOCK AND DATE
ALARM
2
SCD1990SW / English Instruction Manual