Operation; Informationen On Initial Start-Up; Test Run Initial Start-Up; Notes For The First 20 Operating Hours - Zipper Maschinen ZI-BRM420 Manuel D'utilisation

16

OPERATION

Only put the machine into operation after you have read and understood the safety instructions
and carried out the necessary measures before initial commissioning..

Informationen on Initial Start-up

16.1.1 Test Run Initial Start-up

 Let the machine run idle for about 3 minutes.
 Watch out for abnormal noises.
 Pay attention to the exhaust fumes (too black, too white)?

16.1.2 Notes for the first 20 operating hours

In order to optimize the life expectancy of your machine, the following points should be observed:
 Spare the engine for the first 20 operating hours (this also applies to used engines after
extensive maintenance). This means lower speed and lower maximum working load than
during normal operation.
 Change the engine oil after the first 20 hours of operation.

Operating instructions

 Never tighten the cable while the engine is running. This will damage the motor.
 The pull mechanism for changing the motor speed is limited by an adjusting screw. This is
factory set. Never change this setting on your own, you could overload the motor.
 Under no circumstances should you operate the machine on slopes of more than 20°, as
even with an optimum oil level the engine may not be supplied with sufficient lubrication.
 In the direction of the forward movement of the machine and within a range of one meter
around the machine, nobody but the operator must stand.
 Pay particular attention to the following particularly dangerous areas:
 Special precautions must be taken when mowing on slopes. Only mow crosswise to the
slope, never downwards or upwards, observing the maximum permissible slope angle.
 The cutting height can be adjusted by means of a lever on the machine, adjust it to the
respective condition of the lawn to be worked.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-BRM420 und ZI-BRM508
The machine is delivered without engine oil and fuel. Make sure that this
equipment is filled up before the machine is put into operation for the first time.
The machine does not start until engine oil has been refilled to the
upper limit (low oil lubrication)!
NOTICE
OPERATION
33