14
OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be used.
Check in particular the safety equipment, controls and screwed connection for damage and if
tightened properly. Replace any damaged parts before operating the device.
14.1 Operation instructions
No cleaning, upkeep, checks or maintenance when machine is running
Shut off the machine and let it cool down before start servicing!
Mower should be started only with correctly mounted grass box or side
discharge.
Switch off the engine before adjusting the cutting height or before you
empty the grass box.!
While starting or working never raise the mower!
14.2 Start up
14.2.1 Fill in engine oil
ATTENTION! Fill up with 4-stroke quality motor oil before first operation!
Failure to do so will result in permanent engine damage and void guarantee!
Use engine oil (SF 15W40)
Remove oil dipstock
Fill in engine oil (Engine oil tank capacity 0,6l: do not overfill!)
Tighten the oil dipstock
Wipe any oil residues
14.2.2 Check oil level
Place machine on a level ground
Remove oil dipstick
Wipe oil from the dipstick
Replace the dipstick without tightening the oil cap!
Pull out the dipstick again.
Check the oil level. Oil level must be between min
and max
Fill in oil if low level
Retighten the oil dipstick
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
ZI-BRM52EST
WARNING
NOTICE
WARNING
OPERATION
29