Safety Instructions - Zipper Maschinen ZI-BRM52EST Manuel D'utilisation

12.2 Safety instructions

Missing or non-readable security stickers have to be replaced immediately!
The locally applicable laws and regulations may specify the minimum age of the operator
and limit the use of this machine!
To avoid malfunction, machine defects and injuries, read the following security instructions:
 Use the machine only in good enough light to allow a safe operation can be guaranteed.
 In tiredness, decreased concentration or under the influence of alcohol or drugs, the
work on the machine is prohibited!
 Caution in slippery conditions - slip hazard - risk of injury. When working, robust and
non-slip footwear. Slides / stumble / traps are a major cause of serious injury or
death.
 The machine must be operated only by trained persons (knowledge and understanding
of this manual), which have no limitations of motor skills compared with conventional
workers.
 Unauthorized persons, especially children and not trained personnel must be kept away
from the running machine!
 If you pass the machine to third, these instructions must be attached to the machine.
 Before each use, the reliability of the machine is to be checked (tightness of the cutting
tool, the proper function)
 Danger of burns! During the operation flow of hot exhaust gases and engine parts such
as the carburettor and engine become hot.
 After the operation, the machine must cool down. Otherwise there is an imminent risk
of burns
 Work attentively, safety conscious and always be fully aware safe stand when working!
 Caution on uneven work surfaces and work surfaces with a slope!
 Inspect the area to be cut before you begin work. Remove any foreign objects (such as
stones). Look out for foreign objects (such as stones) while you are working.
 Never leave the machine unattended where you are working. If you stop work, unplug
the safety switch (if equipped) and store the machine in a safe place.
 Never use the machine when it is raining or in damp, wet areas.
 Regular breaks reduce the security risk to loss of control due to fatigue.
 Walk! Never run with the machine
 Always work transversely to the slope, never up and down
 Be especially careful when you turn the machine or move backwards!
 No other person (especially children) or pets shall remain within 15m!
 This distance also adhere to things cause danger of damage!
 Use personal safety equipment: safety gloves (when working on the blades), safety
shoes, ear protection and work wear when working with the machine
 Do not grab in the cutting tool while it is rotating
 Take care that you do not get under the cutting tool!
 Switch off the machine when it must be transported over another surface as grass or it
must be tilted for transport to and from a processing area.
 Start or operate the starter with caution according to the instructions, take care that
there is sufficient distance between the feet and the cutting tool
 WARNING: Gasoline is highly flammable!
 Smoking and open flames are prohibited during refuelling. Do not refuel when the
engine and carburettor are still very hot.
 Refuel only outdoors or in a well ventilated area.
 Avoid contact with skin and clothes (fire hazard).
 Check after refuelling tank cap and check for leaks.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-BRM52EST
SAFETY
25