Operation Instructions; Engine Start; Stop The Engine - Zipper Maschinen ZI-MOS4TA Manuel D'utilisation

13 OPERATION
Machine to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating the
device.

13.1 Operation instructions

 Shut off the machine and let it cool down before start any cleaning, upkeep, checks or
maintenance!
 Operate the machine always with belt!
 In dangerous situations detach the machine with the quick release from shoulder strap
 Make sure the fuel and tank are in perfect condition before each start!
ATTENTION! For transport engine oil has been drained. Fill up with 4-stroke
quality motor oil before first operation! Failure to do so will result in
permanent motor damage and void guarantee!

13.2 Engine Start

13.3 Stop the engine

• Release the throttle lever and set the mainswitch (1) to position off „0".
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-MOS4TA
NOTICE
W A R N I N G
INHALT / INDEX / INDICE/
1. switch main switch (1) to "I"
= machine ready for
operation
2. set the start speed: Press
release lever (2) and throttle
lever (4) and press holder
(3)
3. close the choke (5) (in upper
position)
4. press primary pump (6) 2-3
times
5. grasp the start cable and pull
it slowly until resistance is
felt, let the cable rewind
slightly from this point and
pull it forcefully.
6. when the engine runs
smoothly, open the choke
(5) (lower position)
25