Zipper Maschinen ZI-MOS4TA Manuel D'utilisation page 20

 Refuel only outdoors or in a well ventilated area.
 Avoid contact with skin and clothes (fire hazard).
 Check after refuelling tank cap and check for leaks.
 Start the engine at least 3 meters from the tank location.
 Spilled fuel is wipe immediately.
 Work attentively, safety conscious and always be fully aware safe stand when working! Caution
on uneven work surfaces and work surfaces with a slope!
 Never cutting:
- above hip height
- on a ladder
- on trees
 Regular breaks reduce the security risk to loss of control due to fatigue. Change the working
position over again.
 Avoid abnormal posture.
 At idle, the blade should not rotate!
 The maximum shaft speed must not exceed the specified speed. Checked settings!
 No other person shall remain within 15m!
 This distance also adhere to things! Danger of damage!
 Solid objects, stones, metal parts, or the like can be thrown out - risk of injury!
 Use personal safety equipment: ear protectors, safety goggles, safety shoes and safety helmet
when working with the machine
 Never leave the machine running unattended! Before leaving the working area switch the
machine off and wait until the machine stops.
 Switch off the machine before maintenance or adjustment.
 Storage always with an empty tank in a safe place.
 Do not grab in the cutting tool while it is rotating.
 Take care that you do not get under the cutting tool!
 Always use the correct cutting tool for the work to be done.
 Do not operate in an enclosed or confined areas.
 Exhaust contains poisonous carbon monoxide. The exposure can cause unconsciousness and
death.
 Before the start, after the failure or shock, be sure to check the device and make sure that it is
in good condition.
 Wear firm gloves when you use the brush cutter or if you install or remove the cutting blade.
TRANSPORT NOTES:
 Switch off the engine
 Fit the blade guard
 Secure the machine
 Empty tank completely, avoid fuel spillage
 To avoid damage to the device never drag but always lift correctly.
STORAGE NOTES:
 Remove and clean thread head and cutter blade
 Fit the blade guard
 Clean the machine and dry
 Empty Tank completely, avoid fuel spillage
 Store in a dry, out of reach of children place, well packaged (protection against cuts)
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-MOS4TA
INHALT / INDEX / INDICE/
20