Zipper Maschinen ZI-MOS4TA Manuel D'utilisation page 24

Assembly tooth blade:
1. Fix the upper holder (3) with the Allen key (2). (Push the Allen key through both
holes. The hole on the upper holder (3) must first be aligned by turning.
2. Attach the tooth blade (4)
3. Attach the flange (5)
4. Attach the flange (6) and nut (7) und fasten the nut (7)
Left-hand thread
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-MOS4TA
NOTE
INHALT / INDEX / INDICE/
Assembly safety guard
Assemble the safety guard (1) to the rod
using two screws (3)
Assembly nylon cutter
1. Fix the upper holder (3) with the Allen
key (2). (Push the Allen key through
both holes. The hole on the upper
holder (3) must first be aligned by
turning.
2. put the nylon cutter (4) on the thread
(1) and tighten it
NOTE
Left-hand thread
24