Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
17
MAINTENANCE
Hot surfaces and rotating machine parts while the engine is running can cause
serious injury or even death. Always stop the machine before carrying out any
conversion, adjustment, cleaning or maintenance work, let it cool down and secure it
against unintentional restarting.
Maintenace and Servicing Plan
What to do?
Check fuel level
Check engine oil level
Control of the operating elements
Check for damaged parts
Checking for loose or lost screws
Change engine oil
Air filter cleaning/replacement
Spark plug test/replacement
Fuelfilter cleaning
The specified intervals refer to working under "normal" operating conditions. Depending on the
load, a change/exchange may also be necessary at an earlier point in time.
Changing the Engine Oil
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
ZI-BRM420 und ZI-BRM508
The machine is delivered without engine oil and fuel. Make sure that this
operating resources are filled up before the machine is put into operation for
the first time.The machine does not start until engine oil has been
refilled to the upper limit (insufficient oil lubrication)!
3. Release brake lever
WARNING
frequency
before each start-up
before each start-up
before each start-up
before each start-up
before each start-up
First after 5h or 1 month , then every 3
months or 25h
every 25h or 3 months
every 200 h or 2 years
every 25h or 3 months
NOTICE
MAINTENANCE
36
Publicité
Table des Matières
