9) To interrupt the cooking process, press the
BOUILLIR/VAPEUR button q or the MARCHE/
ARRÊT button e.
10) Remove the lid 2 carefully.
11) Remove the egg insert 7 from the blender
jug 3.
Heat-up
GB
You can also reheat soups that you have made
earlier with the appliance.
NOTE
►
Before using the TIÉDIR function, the blender
jug 3 must be cleaned thoroughly. Ensure
that no food residue remains at the bottom
of the appliance.
1) Insert the plug into a mains power socket.
The appliance emits an acoustic signal.
2) Pour in the soup to be heated up.
3) Press the MARCHE/ARRÊT button e. The
appliance emits an acoustic signal. All control
lamps fl ash.
4) Press the TIÉDIR button r. Two signal tones
will confi rm your selection and the corresponding
signal lamp will fl ash.
The heating of the soup now takes place automatic-
ally: The appliance heats and mixes alternately.
As soon as the heating process is complete, the
appliance will stop automatically.
NOTE
►
You can stop the heating process at any time
by pressing the MARCHE/ARRÊT button e
or the TIÉDIR button r. The control lamp then
goes off and the appliance switches itself off .
36
All manuals and user guides at all-guides.com
Cleaning and care
It is best to clean the appliance as soon as it has
cooled down after each use. Dried-on food residue
is more diffi cult to remove.
Cleaning the blender jug
►
►
1) Insert the plug into a mains power socket.
2) Add a little warm water and a drop of
3) Close the lid 2.
4) Press the MARCHE/ARRÊT button e.
5) Press the IMPULSION button t and allow the
6) Remove the plug from the mains power socket.
7) Remove stubborn remains using the cleaning
8) Afterwards, empty the container and rinse it
DANGER – ELECTRIC SHOCK!
Ensure that no liquids come into contact with
the electrical connector on the blender jug 3!
NEVER immerse the blender jug 3 in
water or other liquids! Otherwise there
is a risk of an electric shock.
WARNING! RISK OF INJURY!
Take care when cleaning the blender jug 3.
The blade 4 is very sharp!
The appliance emits an acoustic signal.
washing up liquid to the blender jug 3.
appliance to run for about 1 minute.
brush 8 or the cleaning sponge 0. The narrow
side of the cleaning brush 8 is particularly
well-suited to removing food residue from the
bottom of the appliance.
out thoroughly with clear water.
SSK 300 A1