Before Fi Rst Use; Assembling The Appliance - SilverCrest SSK 300 A1 Mode D'emploi

WARNING!
THERE IS A RISK OF INJURY!
► Overfi lling the blender jug can lead to hot
liquid splashing out during food preparation!
Risk of scalding! Always pay attention to the
markings on the blender jug!
► Always remove the lid carefully, opening it
GB facing away from you so that steam can
escape towards the rear. Do not lean over
the appliance while it is boiling. Use a dish
cloth or oven gloves when touching the lid
and the blender jug.
Caution! Hot surface!
ATTENTION! RISK OF FIRE!
► Do not operate the appliance in the vicinity
of or under curtains, wall-mounted cupboards
or other fl ammable materials.
► Place the appliance on a heat-resistant surface
(not on varnished tables or tablecloths). Do not
operate it close to other heat sources (cooker,
gas fl ame). Otherwise there is a danger of
damage to the appliance and/or furniture.
► Place the appliance on a level and stable
surface. Ensure that it is set up at a suffi cient
distance to walls and cupboards. This will
ensure that you avoid damage caused by
rising steam.
► Never operate the appliance via an external
time-switch or a separate remote control system.
ATTENTION! DAMAGE TO PROPERTY!
► Never operate the appliance when it is empty,
in other words, without any ingredients in the
blender attachment.
32
All manuals and user guides at all-guides.com
Before fi rst use
■
■
■

Assembling the appliance

NOTE
►
1) Place the measuring cup 1 in the lid 2 so
2) Turn the measuring cup 1 clockwise a little
3) If required, place the puree fi lter 9 centrally
4) Place the lid 2 slightly off set on the blender
5) Place the blender jug 3 on the motor block 5
NOTE
►
Remove all packaging materials from the appli-
ance.
Clean the appliance as described in the section
"Cleaning and Care".
Ensure that all parts are completely dry before
operating the appliance.
The appliance cannot be switched on until all
parts are correctly assembled.
that the two plastic tabs on the measuring
cup 1 fi t into the notches on the lid 2.
way so that it sits tightly.
above the blade 4.
jug 3 (the arrow on the handle points to the
opened lock ). Now turn it until the catches
on the lid 2 engage in the grooves on the blend-
er jug 3 and click fi rmly into place (the arrow on
the handle points to the closed lock
also fi xes the puree fi lter 9 into place.
so that the contacts on the blender jug 3 con-
nect with the sockets on the motor block 5
(when the mains plug is connected, the cor-
rect placement of the blender jug 3 will be
confi rmed by a signal tone).
Place the egg insert 7 as far as it will go into
the blender jug 3 until it is fi rmly in place. The
handle of the egg insert 7 will be pointing
upwards.
).The lid 2
SSK 300 A1