What To Do If - AEG 66030K-MN Notice D'utilisation

18

What to do if ...

What to do if ...
The cooking zones will not
switch on or are not function-
ing
Acoustic signal sounds when
appliance is switched off
The residual heat indicator is
not displaying anything
The automatic warm up func-
tion is not switching itself on
Acoustic signal sounds and
appliance switches itself on
and then off again; after 5
seconds another acoustic sig-
nal sounds
is lit
Problem
More than 10 seconds have
passed since the appliance was
switched on
The child safety device is
switched on
Several sensor fields were
touched at the same time
Automatic switch off has been
triggered
The lock is switched on
The control panel is wholly or
partly covered by objects.
The cooking zone was only on
for a short time and is there-
fore not hot
There is still residual heat on
the cooking zone
The highest heat setting is set The highest heat setting has
The heat setting was set using
the sensor field
The On/Off sensor field has
been covered up, e.g. by a
cloth
Overheating protection for the
cooking zone has been trig-
gered
Automatic switch off has been
triggered
Possible cause Remedy
Switch the appliance on again.
Deactivate the child safety de-
vice (See the section "Child
safety device")
Only touch one sensor field
Remove any objects (pan,
cloths, etc.) that are lying on
the control panel. Switch the
appliance on again
Switch off the lock (See the
section "Locking/unlocking the
control panel")
Remove objects.
If the cooking zone is sup-
posed to be hot, call the Cus-
tomer Service Department.
Let the cooking zone cool
down
the same power as the auto-
matic warm up function
1. Switching off the cooking
zone
1. Set the cooking zone using
the sensor field
Do not place any objects on
the control panel
Switch off the cooking zone.
Switch the cooking zone on
again
Switch off the cooking zone.
Switch the cooking zone on
again