What To Do If - AEG 63070 K-MN Notice D'utilisation

Table de cuisson vetrocéramique à induction
Masquer les pouces Voir aussi pour 63070 K-MN:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

What to do if ...

Problem
The cooking zones are not
functioning
The residual heat indicator
is not displaying anything
Display is switching
between two heat settings
lights up
lights up
and number are
displayed
If you are unable to remedy the problem by following the above sugges-
tions, please contact your dealer or the Customer Care Department.
1
Warning! Repairs to the appliance are only to be carried out by qualified service
engineers. Considerable danger to the user may result from improper repairs.
3
If the appliance has been wrongly operated, the visit from the customer service tech-
nician or dealer may not take place free of charge, even during the warranty period.
All manuals and user guides at all-guides.com
Possible cause
The desired heat setting is not set Set heat setting
The fuse in the house's electrical
wiring (fuse box) has been tripped.
The child safety device is switched
on.
is lit
The cooking zone was only on for
a short time and is therefore not
hot
Power management is reducing
the power of this cooking zone
Unsuitable cookware
No cookware on the cooking zone Place cookware on the cooking
The diameter of the bottom of the
cookware is too small for the
cooking zone
The cooking zone's overheating
protection has been triggered
Cooking zone on for more than
two minutes without cookware
Automatic switch-off has been
triggered
Electronics fault
What to do if ...
Remedy
Check the fuses.
If the fuses trip repeatedly,
please call an authorised
electrician.
Switching off the child safty
device (see section "Child safety
device" in the hob user manual)
If the cooking zone is supposed
to be hot, call the Customer
Service Department.
See the section "Switching the
power function on and off"
Use suitable cookware
zone
Move onto a smaller cooking
zone
Use suitable cookware
Switch off the cooking zone.
Switch the cooking zone on
again
Switch off cooking zone, place
cookware on cooking zone,
switch on cooking zone
Switch off the cooking zone.
Switch the cooking zone on
again
Disconnect the appliance from
the electrical supply for a few
minutes (Take the fuse out of
the house's wiring system)
If after switching on again,
is displayed again, call the cus-
tomer service department
15

Publicité

Table des Matières
loading

Table des Matières