DURAVIT sensoWASH D-CODE Notice D'utilisation page 57

Removing the seat unit
> Unplug the power cable from the electrical socket.
> Close the water cut-off valve.
> Pull the product forwards by holding it securely on both sides while pressing on
the button at the bottom right of the product.
The seat unit is now separated from the installation plate.
> Remove the drain plug on the rear of the SensoWash
anticlockwise.
> Pull the drain plug forwards to let the water in the hot water reservoir drain into
the toilet bowl.
Cleaning the fine filter
> Remove the product from the installation plate.
> Remove the fine filter at the left rear of the product.
> Use a screwdriver to remove the fine filter.
> Use a soft brush to clean the fine filter under running cold water.
The cleaning cycles may vary depending on the water quality.
If the water flow is less than usual, clean the fine filter on both sides.
Ensure that the water supply hose is switched off during the cleaning process.
Control panel
> Clean the control panel with a soft, possibly damp cloth.
All manuals and user guides at all-guides.com
D-Code by turning it 90°
®
EN
47