Emc Information - Philips SmartSleep Manuel D'utilisation

— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
— Consult the dealer of the device for help.
• Any changes or modifications made to the device that are not expressly approved by
Respironics may void the user's authority to operate the equipment.

EMC Information

Guidance and Manufacturer's Declaration - Electromagnetic Emissions - This device is
intended for use in the electromagnetic environment specified below. The user of this
device should make sure it is used in such an environment.
E T
missions EsT
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
Flicker emissions
IEC 61000-3-3
Emission of Radio
Frequency Energy
RTCA/DO-160G
Section 21
Guidance and Manufacturer's Declaration - Electromagnetic Immunity - This device is
intended for use in the electromagnetic environment specified below. The user of this
device should make sure it is used in such an environment.
i T
mmuniTy EsT
Electrostatic
Discharge
(ESD)
IEC 61000-4-2
Electrical Fast
Transient/Burst
IEC 61000-4-4
Surge
IEC 61000-4-5
C
omplianCE
Group 1
Class B
Class A
Complies
Category M
iEC 60601-1-2 C
omplianCE
T l
EsT EvEl
±8kV contact ±8kV contact
±2kV, ±4kV, ±2kV, ±4kV, ±8kV,
±8kV, & ±15kV air & ±15kV air
±2kV for powers ±2KV for Power
supply lines Supply Lines
±1 kV for input- NA - Device does
output lines not have user
I/O lines that are
longer than 3 m in
length.
±1 kV Line to ±1 kV Line to Line
Line NA - The device
±2 KV Line to is a Class II device
Ground and does not
connect to earth
ground.
E E
lECTromagnETiC nvironmEnT
The device uses RF energy only for its internal
function. Therefore, its RF emissions are very low
and are not likely to cause any interference in
nearby electronic equipment.
The device is suitable for use in all
establishments, including domestic
establishments and those directly connected to
the public low-voltage charger network.
This device is suitable for use onboard
commercial airplanes inside passenger cabin.
l E
EvEl lECTromagnETiC
g
uidanCE
Floors should be wood, concrete or
ceramic tile. If floors are covered with
synthetic material, the relative humidity
should be at least 30 %
Mains power quality should be that of a
typical home or hospital environment.
Mains power quality should be that of a
typical home or hospital environment.
- g
uidanCE
E -
nvironmEnT
19