Troubleshooting - Philips MZ-5 Mode D'emploi

XP MZ5/37 15-03-2002 11:23

Troubleshooting

WARNING
Do not open the set as there is a risk of electric shock! Under no circumstances should you try
to repair the set yourself, as this will invalidate the warranty
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service
center.
Problem
No sound /power
No reaction to controls
TIMER/SLEEPER
does not work
Severe radio hum or noise
Poor radio reception
NO DISC or
DISC NOTREADABLE
indication
The CD skips tracks
Remote control does
not function properly
Pagina 17
Solution
– Volume not adjusted. Adjust the VOLUME.
– Headphones connected. Disconnect headphones.
– AC mains not securely plugged to wall outlet. Plug in properly.
– Electrostatic discharge.
Disconnect the unit from the AC power supply reconnect after
a few seconds.
– Clock time not set. Set the correct clock time.
– Electrical interference set too close to TV,VCR or computer.
Increase the distance.
– Weak radio signal.
FM: Direct the FM antennawire for optimum reception.
– CD badly scratched or dirty. Replace/ clean CD, see Maintenance.
– CD-R(W) is blank or the disc is not finalised. Use a finalised CD-R(W).
– Laser lens steamed up.Wait until lens has cleared.
– CD damaged or dirty. Replace or clean CD.
– SHUFFLE or PROGRAM is active. Switch off SHUFFLE/ PROGRAM.
– Batteries exhausted. Insert fresh batteries
– Batteries incorrectly inserted. Insert the batteries correctly.
– Distance/ angle between the set too large.
Reduce the distance/ angle.
17