Erasing A Program; Cd Player And Cd Handling; Tuner; Tuning To Radio Stations - Philips MZ-5 Mode D'emploi

XP MZ5/37 15-03-2002 11:23
CD Player

Erasing a program

You can erase the program by:
– pressing 9 once in the STOP position;
– pressing 9 twice during playback;
– opening the CD tray.
• CLEARED is shown briefly and
disappears from the display.

CD player and CD handling

• If the CD player cannot read CDs correctly, use a
commonly available cleaning CD to clean the lens
before taking the set to repair. Other cleaning
methods may destroy the lens.
X
• The lens of the CD player should never be
touched!
• Sudden changes in the surrounding temperature
can cause condensation to cloud over on the
lens of your CD player. Playing a CD is then not
possible. Do not attempt to clean the lens but
leave the set in a warm environment until the
moisture evaporates.
• Always keep the CD compartment closed to
avoid dust on the lens.
• To take a CD out of its box, press the center
spindle while lifting the CD. Always pick up the
CD by the edge and return the CD to its box
after use to avoid scratching and dust.
• To clean the CD, wipe in a straight line from the
center towards the edge using a soft, lint-free
cloth. Do not use cleaning agents as they may
damage the disc.
• Never write on a CD or attach any stickers to it.
Pagina 15

Tuning to radio stations

PROGRAM
1 Select TUNER source.
TUNER is displayed briefly.
2 Press BAND (or SOURCE on the set for 2 or
more seconds) to select your waveband.
3 To tune to a station, press TUNING ¡1 or 2™
(on the remote control 11 or 22) and release
when search tuning starts.
The radio automatically tunes to a station
with sufficient reception. Display indication
during automatic tuning: SEARCH.
If a FM station is received in stereo,
shown.
4 Repeat step 3 if necessary until you find the
desired station.
To tune to a weak station, press 5 or 6 briefly
•
and repeatedly until you have found optimal
reception.

Programming radio stations

You can store up to a total of 40 radio stations in
the memory.
Automatic programming
Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overwritten.The unit will only program
stations which are not in the memory already.
1 Press PRESET 4 or 3 (¡ or ™ on the remote
control) to select the preset number where
programming should start.
Note: If no preset number is selected, default is
preset 1 and all your presets will be overwritten.
MC 158 CO MP MC 158 CO MP
AC T AU DIO AC T AU DIO
IO IO
IO IO SYS TEM SYS TEM
IO IO
II II
IO IO
II II
IO IO
II II
IO IO
IO IO
I II I II

Tuner

OPEN OPEN
CLOSE CLOSE
PRESET PRESET
TUNING TUNING
is
STEREO
15