Denon ADV-M71 Mode D'emploi page 52

ENGLISH
[2] 2-channel mode settings
• When 2-channel signals are input, one of two playback modes can be selected and set according to the 2-channel mode setting, Virtual 1 or
Virtual 2. (The Virtual 1 mode is set by factory default.)
Virtual 1 : 2-channel sources are played in virtual surround using Dolby Pro Logic
Virtual 1 : 2-channel sources are played in virtual surround using Dolby Pro Logic processing.
B
DVD SURROUND RECEIVER ADV-M71
ON / STANDBY
NOTES:
• The 2-channel mode cannot be set when Dolby Digital or DTS
5.1-channel signals.
• The 2-channel mode is set and stored in the memory individually
for the different functions.
52
1,2,3
SURROUND / SELECT
PUSH - PARAM.
- +
MENU / SET
TONE / SDB
VOLUME
FUNCTION
PHONES
TEST TONE INPUT MODE SURROUND FUNCTION
1
TUNER TV / VCR
A / V DVD IN/SURR.
SYSTEM MD IN/SURR.
CDR TAPE
1 2 +
DVD
8 9
-
6 7
STATUS
3 MUTING
SETUP TONE /SDB
3
ENTER
SURROUND
CH SELECT PARAMETER
2
- +
VCR CH
RETURN DISPLAY MENU TOP MENU
ANGLE AUDIO SUB TITLE
RC-966
II Cinema processing.
1 Set the surround mode to "DOLBY VIRTUAL SPEAKER"
("DOLBY VS").
• The normal display reappears after the surround mode is
displayed.
BAND
2 Press the SURROUND PARAMETER
button and select the 2-channel
mode.
2
This can be selected if there is no
digital input signal, if the digital
input is a PCM or Dolby Digital 2-
channel signal and if the input is
analog.
3 Turn the SURROUND/SELECT control on the main unit or use
the 0
select the desired 2-channel mode.
VIRTUAL 1
Once the surround parameters have been set, stop operating the
buttons. After several seconds, the normal display reappears and
the settings are automatically entered
SURROUND / SELECT
PUSH - PARAM.
Main unit Remote control unit
V I R T U A L 1
1 cursor buttons on the remote control unit to
and
SURROUND / SELECT
PUSH - PARAM.
Main unit Remote control unit
VIRTUAL 2
SURROUND
SURROUND / SELECT
PUSH - PARAM.
Main unit
SURROUND
PARAMETER
Remote control unit