Denon ADV-M71 Mode D'emploi page 32

ENGLISH
9 Use the • and ª cursor buttons
to select "ROOM SPACE", then
1
use the 0 and
to set the size of the room.
• The set size is displayed in
yellow.
Use the • and ª cursor buttons
10
to select "SEATING POSITION",
then use the
0
buttons to set the position.
• The set position is displayed in
yellow.
11 Press the ENTER button to end the
settings.
• The screen in step 2 reappears.
12 Press the SETUP button to quit the
setup mode.
The setup mode can also be quit by
using use the • and ª cursor buttons
at the setup screen to select "EXIT
SETUP" then pressing the ENTER
button.
32
cursor buttons
Remote control unit
1 cursor
and
Remote control unit
ENTER
Remote control unit
SETUP
Remote control unit
About the speaker system settings
2CH VIRTUAL
B
Select this when only using with the two speakers for the front
channels.
2CH VIRTUAL & SW
B
Select this when using two speakers for the front channels and
a subwoofer with built-in amplifier.
• Settings
Front : Small
Subwoofer : Yes
Subwoofer frequency : 150 Hz
Set the front speakers and subwoofer at equal distances.
5.1CH SURROUND
B
Select this when using two speakers for the front channels, a
center speaker, two speakers for the surround channels and a
subwoofer with built-in amplifier.
• Settings
Front : Small
Center : Small
Surround : Small
Subwoofer : Yes
Subwoofer frequency : 150 Hz
The room setting is set to "MED.", the listening position to
"BACK".
NOTE:
• The speaker system is set to "2CH VIRTUAL" upon shipment
from the factory. If using speakers for the two front channels and
a subwoofer, change the setting to "2CH VIRTUAL & SW".
2.7m (9ft)
2.4m (8ft)
2.1m (7ft)
2.7m (9ft)