Denon ADV-M71 Mode D'emploi page 13

(6) Sound output from this unit digital and analog audio output connectors
2 When a disc is played on the ADV-M71 (DIGITAL OUT)
Audio recording format
Dolby Digital
DTS
DVD video
MPEG audio
DVD audio
(video part only)
48 kHz
96 kHz
CP : OFF
Video CD MPEG 1
Music CD Linear PCM
MP3/WMA CD MP3/WMA
• Linear PCM audio is the signal recording format used for music CDs.
While the signals are recorded at 44.1 kHz/16 bit for music CDs, for DVDs they are recorded at 48 kHz/16 bit to 96 kHz/24 bit, providing higher
sound quality than music CDs.
2 About the LINE-1 and LINE-2 analog recording outputs
When the DVD or the D.AUX digital input is selected:
• Dolby Digital, DTS and PCM digital signals are automatically converted to 2-channel stereo signals before being output (except when in the
Dolby Headphone mode) and can be recorded in analog. (For what happens in the Dolby Headphone mode, see below.)
When TUNER, LINE-1 or LINE-2 is selected:
• The selected analog audio signals from the tuner or from the device connected to the LINE-1 or LINE-2 analog input terminals (IN) are output
unchanged, regardless of the ADV-M71's input mode or surround mode. (The same is true for the device connected to the D.AUX terminals
when "LINE-2" under "⁄0 SETTING UP THE SYSTEM – (3) Detailed system setup – [6] Function settings" is set to "D.AUX".)
Recording output during playback of a DVD or D.AUX digital input source in the Dolby Headphone mode:
• In the Dolby Headphone mode with a DVD or a digital input selected, the Dolby Headphone mode analog audio signals currently being played
are output and can be recorded in analog. (See pages 58 and 59.)
Cautions during analog recording of DVDs or digital input sources:
• Do not switch the ADV-M71's input mode, surround mode or surround parameters during recording. Doing so will interrupt the sound being
recorded.
We recommend setting the surround mode to "STEREO" or "DIRECT".
• When using headphones, recording is automatically performed in the Dolby Headphone mode. Do not disconnect the headphones or
switch the headphones mode during recording.
Settings
Digital out : Normal
Digital out : PCM conversion
Digital out : Normal
Digital out : PCM conversion
Digital out : Normal
Digital out : PCM conversion
LPCM conversion mode : OFF
LPCM conversion mode : ON
LPCM conversion mode : ON
CP : ON LPCM conversion mode : OFF
LPCM conversion mode : OFF
Refer to
Digital audio data output
page
Dolby Digital bitstream
2 channels PCM data (48 kHz/16bit)
101
DTS bitstream
2 channels PCM data (48 kHz/16bit)
2 channels PCM data (48 kHz/16bit)
101
2 channels PCM data (48 kHz/16bit)
48 kHz/16 ~24 bit PCM
48 kHz/16 bit PCM
101 48 kHz/16 bit PCM
48 kHz/16 bit PCM (when copy-protected)
96 kHz PCM (when not copy-protected)
44.1 kHz/16 bit PCM
44.1 kHz/16 bit PCM
32 ~ 48 kHz/16 bit PCM
ENGLISH
13