Denon ADV-M71 Mode D'emploi page 51

6 Select and set the
parameters.
(On the remote control unit, use the
0 , 1 cursor buttons to set the
parameters.)
If nothing is done for 6 seconds
from when the parameter is
displayed, the normal display
reappears.
Setting the DOLBY VS mode
B
V S R E F W I D E
The selected mode flashes.
The mode is not displayed if it cannot be selected.
D.COMP. setting
B
D . C O M P . O F F
OFF LOW
Setting the LFE level
B
L F E
...
-10
The LFE level can be adjusted in steps of 1 dB between -
10 dB and 0 dB.
DEFAULT setting
B
D E F A U L T
YES
When "YES" is selected, the settings are restored to the
factory defaults.
When the surround parameters are displayed, use the • and ª
cursor buttons on the remote control unit to switch to previous or
following items.
Once the surround parameters have been set, stop operating the
buttons. After several seconds, the normal display reappears and
the settings are automatically entered.
surround
SURROUND / SELECT
PUSH - PARAM.
Main unit
MID HI
, /
0 d B
...
-5 0
, /
Y / N
NO
, /
Surround parameters (1)
DOLBY VS (Dolby Virtual Speaker mode)
• REF (Reference mode)
This is the standard mode.
• WIDE (Wide mode)
This mode expands the front channel sound field.
D.COMP. (Dynamic range compression)
• This parameter adjusts the dynamic range of the Dolby
Digital sound. When listening with the volume turned
relatively low, at night for example, set this to the "HI" side
to lower the peak of the sound and amplify the quieter
sounds, narrowing the dynamic range and making the sound
easier to listen to. Set to "OFF" to turn this function off.
OFF LOW
Wide
Dynamic range
LFE (Low Frequency Effect):
• Program source and adjustment range
1. Dolby Digital : –10 dB to 0 dB
2. DTS Surround : –10 dB to 0 dB
• When Dolby Digital encoded software is played, it is
recommended that the LFE LEVEL be set to 0 dB for correct
Dolby Digital playback.
• When DTS encoded movie software is played, it is
recommended that the LFE LEVEL be set to 0 dB for correct
DTS playback.
• When DTS encoded music software is played, it is
recommended that the LFE LEVEL be set to –10 dB for
correct DTS playback.
ENGLISH
MID HI
Narrow
51