Installation; Gas Connection - AEG HC411520GB Notice D'utilisation

tion holes open or install a mechanical ventilation device (mechanical extractor
hood).
• More ventilation (for example opening of a window or increasing the level of me-
chanical ventilation where present) is necessary when you intensive operate the ap-
pliance for a long time.
If, you use the accessory frame C-FRAME, first read the instruction supplied with the frame
before you install the appliance.
WARNING!
Risk of injury from electrical current. Carefully obey the instructions for electrical connec-
tions.
• The electrical mains terminal is live.
• Make electrical mains terminal free of voltage.
• Install correctly to give anti-shock protection.
• Loose and incorrect mains plug and socket connections can make the terminal become
too hot.
• A qualified electrician must install the clamping connections correctly.
• Use a strain relief clamp on cable.
• Use the correct mains connection cable and replace the damaged mains cable with prop-
er special cable. Speak your local Service Force Centre.
The appliance must have the electrical installation which lets you disconnect the appliance
from the mains at all poles with a contact opening width of minimum 3 mm.
You must have correct isolation devices: line protecting cut-outs, fuses (screw type fuses
removed from the holder), ground leakage trips and contactors.
Manufacturer is not responsible for any injury to persons and pets or damage to prop-
erty caused by failure to obey these requirements.

INSTALLATION

Before the installation, note down the serial number (Ser. Nr.) from the rating plate.The
rating plate of the appliance is on its lower casing.
Made in Switzerland
WARNING!
The following instructions about installation, connection and maintenance must be carried
out by qualified personnel in compliance with standards and local regulations in force.

Gas Connection

Make sure that during the installation the appliance is not connected to electrical supply.
Disconnect the mains plug or deactivate the fuses. Disconnect the mains gas supply.
Make sure that there is a stop tap assembled between the gas supply of house and the ap-
pliance.
All manuals and user guides at all-guides.com
Qn (Hs): 5 kW
Butan: 329 g/h
AC 220-240 V 50/60 Hz
10
P<0,025 kW
0063
Adjusted for: G20 2H 2E 2E - 20 mbar
PIN 0063CL3461
Typ: 55 WOK 04 GA
PNC: 941 560 809/00
Serie-Nr:
Mod.: HC411520GB
23
Installation