AEG HC411520GB Notice D'utilisation page 24

24
Installation
The settings for this appliance are located on the rating plate. The present settings for the
type of gas and gas pressure are on a sticker
Choose fixed connections or use a flexible pipe in stainless steel in compliance with the reg-
ulation in force. If you use flexible metallic pipes, be careful they do not come in touch with
mobile parts or they are not squeezed. Also be careful when the hob is put together with an
oven.
This appliance is not connected to an exhaust gas outlet. It must be connected in accord-
ance with the installation conditions that apply. Pay special attention to correct airflow.
Make sure that the gas supply pressure of the appliance obeys the recommended values.
The adjustable connection is fixed to the comprehensive ramp by means of a threaded nut
G 1/2". Screw the parts without force, adjust the connection in the necessary direction and
tighten everything.
1 End of shaft with nut
2 Gasket
3 Elbow
WARNING!
After installation always check the tightness of the connections using a soap solution. Nev-
er use a flame to check the tightness.
Flexible nonmetal pipes connection:
If it is possible to easily control the connection in its full area, you can use a flexible pipe.
Tightly attach the flexible pipe by clamps.
Liquid gas: use the rubber pipe holder. Always engage the gasket. Then continue with the
gas connection. The flexible pipe is prepared for apply when:
– it is no longer than 1500 mm;
– it shows no throttles;
– it is not subject to traction or torsion;
– it does not get in touch with cutting edges or corners;
– it can be easily examined in order to check its condition.
The control of preservation of the flexible pipe consists in checking that:
– it does not show cracks, cuts, marks of burnings on the two ends and on its full length;
– the material is not hardened, but shows its correct elasticity;
– the fastening clamps are not rusted;
– expired term is not due.
All manuals and user guides at all-guides.com
1
2
3