Brief Overview Of The Pictures On The Display - Siemens PolyCool CPS 40 Manuel D'installation Et D'utilisation

Picture Display
1 Display segment test for about 5 s
2 Selection of the circuit
After selecting the circuit, select the following mode with +/- and press <OK> to
confirm.
3 CONF MODE (configuration mode)
4 REFRIG (selection of refrigerant)
5 ENABLE (Enabling/disabling the
compressor and EIV feedback signal)
6 CAP
7 SENSOR
8 RANGE (Measurement range of X4)
9 UNITS
Continously press <ESC> and back to picture 3
10 PARA MODE (parameter mode)
11 ∆T
∆T SP (setpoint of superheat)
(6.0 K / 10.8 °F default)
∆T XP (P-band superheat)
(10 K / 18 °F default)
∆T TN (integral action time superheat)
(30 s default)
∆T D (D-part of superheat)
(0 default)
Continously press <ESC> and back to picture 10
12 CAP
CAP SMX (max. setpoint increase)
CAP SD
(SD=1 indicates that 0 V / 4 mA
corresponds to min. cooling capacity)
CAP SP
CAP XP
CAP TN
Continously press <ESC> and back to picture 12
48/124
Building Technologies
HVAC Products
8 Brief overview of the
pictures on the display
For the values of the setting variables and their increments,
refer to chapter 5.
(18.0 K / 32.4 °F default)
(external signal direction)
(setpoint of capacity control)
(6.0 °C / 42.8 °F default)
(P-band)
(35 K / 63 °F default)
(integral action time)
(5 s default)
CPS40
Procedure
Simutaneously press down +/-
buttons for at least 5 seconds.
Set with +/- and press <OK> to
confirm.
Press <OK> to confirm and proceed
In picture 3, set with +/-
Continue/confirm with <OK>
Exit with <ESC>
Press <OK> to confirm and proceed
Press <OK> to confirm and proceed
In picture 11, set with +/-
Continue/confirm with <OK>
Exit with <ESC>
Press <OK> to confirm and proceed
In picture 12, set with +/-
Continue/confirm with <OK>
Exit with <ESC>
CE1U3372XX / H 74 319 0555 0 a
22.09.2006