Siemens TE 803 Serie Mode D'emploi page 17

Water filter
A new water i lter must be rinsed before it
can be used.
● To do this, press the water i lter i rmly
and press th start
●
Place 1 l container
Place suction pipe in container
● Place a container with a capacity of 1 litre
●
the container.
●
l ow through the i lter to rinse it.
● Next, empty the container.
The appliance is ready for use again.
Info:
Rinsing the i lter simultaneously
activates the setting for the "change i lter"
display.
You can i nd detailed information about the
water i lter in the enclosed i lter instructions.
The i lter is no longer effective when the
Service - change filter
or at the latest after two months. It needs to
that there is no build-up of limescale (this
could damage the appliance).
TE803_806_
All manuals and user guides at all-guides.com
button 8
. Fill the water tank
" mark.
start
.
start

.
. Water will now
display a
setting
Replacement i lters can be obtained from
retailers (TZ70003) or from customer
service (575491).
If no new i lter is used, turn the
.
filter no
are on vacation), the existing i lter should
again. To do this, simply dispense a cup of
hot water.
Transport. lock
●
be completely emptied i rst.
i lled.
●
and switches off.
You ca
● Empty the water tank
.
Factory reset
the factory settings.
●
.
buttons. The appliance must be switched
off fully.
●
> 4 a n d t h e o n / o f f s w i t c h
same time for at least 5 seconds. Press
. The factory settings
are now reactivated.
en
Water
. The appliance
< a n d
1 O / I a t t h e
13
08.