Optional Accessories - DeWalt DW703 Guide D'utilisation

45 degree bevel
Max. Height 2.3" Result Width 3.5"
Max. Width 6.1" Result Height .75"
31.62 degree miter and 33.85 bevel
Max. Width 5.25" Result Height .9"
DRIVE
120 Volt Motor
2200 Watts 15 Amp Motor
5000 RPM Cut Helical Gears with Roller and Ball Bearings
Carbide Blade Automatic Electric Brake

Optional Accessories

The following accessories, designed for your saw, may be helpful. In some cases, other
locally obtained work supports, length stops, clamps, etc., may be more appropriate. Use
care in selecting and using accessories.
Extension, Work Support: DW7080
Used to support long overhanging workpieces, the work support is user assembled.
Your saw table is designed to accept two work supports; one on each side.
Adjustable Length Stop: DW7051
Requires the use of one work support. It is used to make repetitive cuts of the same
length from 0 to 42".
Clamp: DW7082
Used for firmly clamping workpiece to the saw fence for precision cutting.
Crown Molding Fence: DW7084
Used for precision cutting of crown molding.
Miter Saw Work Station: DW730
Workstation provides fast, easy set up for material support and accurate measuring
system.
SAW BLADES: ALWAYS USE 10" SAW BLADES WITH 5/8" (16mm) ARBOR HOLES.
SPEED RATING MUST BE AT LEAST 5500 RPM.
DEWALT NO. OF BLADE
BLADE TEETH DESC.
RANGE
Series 20 40 Thin Kerf
Construction Yellow Rim
Coating
Series 20 60 Thin Kerf
Construction Yellow Rim
Coating
Series 40 40 Laser Cut Body
Woodworking Large Carbide
Teeth
Series 40 60 Laser Cut Body
Woodworking Large Carbide
Teeth
Series 40 80 Laser Cut Body
Woodworking Large Carbide
Teeth
Series 40 80 Laser Cut Body
Woodworking Large Carbide
Teeth, Special
Tooth Geometry
APPLICATION TYPE OF CUT
Gen. Purpose Smooth,
(Trim, Decking, Splinter Free
Framing)
Fine Trim Very Smooth,
Molding Splinter Free
Gen. Purpose Smooth,
(Trim, Decking, Splinter Free
Framing)
Fine Trim, Very Smooth,
Molding Splinter Free
Fine Trim Ultra Smooth,
Molding Splinter Free
Decorative
Hardwood
& Plywood
Melamines, Ultra Smooth
Veneers, Chip/Splinter
Laminates Free
DW7080
LOCKNUTS
END PLATE
DW7051
TOP HOLE
(USE IF ON
LEFT SIDE)
BOTTOM HOLE
KNOBS
BRACKET
3
DW7082
(USE IF ON
RIGHT SIDE)
DW7084