Lenz Digital Plus SILVER+ Mode D'emploi page 22

22
3 Installing the SILVER+, SILVER21+, GOLD+ decoder via interface plug NEM652
(Abb. 2, p. 4)
These decoders come with a NEM652 / NMRA RP-9.1.1 medium plug. This plug makes the
installation of these decoders very simple.
To install the decoder simply remove the dummy plug in your locomotive and install the decoder
plug. To ensure the headlights work correctly you must align the plug properly. Pin 1 of the plug
connects to the orange wire. Ensure this is aligned to Pin 1 of the locomotive. If the plug is installed
wrong way round the lights will not work.
When installing the plug ensure that the pins are not bent or broken.
4 Installing the SILVER 21 decoder (Abb. 3, p. 5)
These decoders come with a 21-pole plug. This plug makes the installation of these decoders very
simple.
To install the decoder simply remove the dummy plug in your locomotive and install the decoder
plug. Ensure Pin 1 of the decoder is aligned to Pin 1 of the locomotive. When installing the plug
ensure that the pins are not bent or broken.
5 Testing the installation
Place the locomotive on the programming track (without its housing) and read the address. The
decoder is programmed ex-works to the address 03. If you have connected the decoder correctly
thus far, you should now be able to read the address. If you are not able to do so, it is possible that
you have made a mistake when connecting the cables. Do not subject the locomotive to full running
track power until you obtain the correct "03" address read-out. Check the cable connections and
Information SILVER+ / GOLD+ Decoder