Ryobi RTS10 Manuel D'utilisation page 39

Problem
Saw does not make accurate 90˚ or
45˚ cuts.
Height/bevel adjusting hand-wheel is
hard to turn.
Saw does not start.
Blade makes poor cuts.
Blade does not lower when turning
height/bevel adjusting handwheel.
Motor labors in rip cut.
All manuals and user guides at all-guides.com
TROUBLESHOOTING
Cause
Positive stops inside cabinet need
adjusting (Bevel Cuts).
Miter gauge is misaligned (Miter Cuts).
Gears or screw post inside cabinet are
clogged with saw dust.
Motor cord or wall cord is not plugged in.
Circuit fuse is blown.
Circuit breaker is tripped.
Cord or switch is damaged.
Blade is dull or dirty.
Blade is wrong type for cut being made.
Blade is mounted backwards.
Locking lever is not at full left position. Move locking lever to left.
Blade not proper for rip cut.
39 - English
Solution
Adjust positive stops.
Adjust the miter gauge.
Clean the gears or screw post.
Plug in motor cord or wall cord.
Replace circuit fuse.
Reset circuit breaker.
Have the cord or switch replaced at
your nearest authorized service center.
Clean, sharpen, or replace blade.
Replace with correct type.
Remount blade.
Change blade; rip blade typically has
fewer teeth.