Ryobi RTS10 Manuel D'utilisation page 36

TO SET THE BLADE AT 0° AND 45°
See Figures 45 - 47.
The angle settings of the saw have been set at the factory
and, unless damaged in shipping, should not require setting
during assembly. After extensive use, they may need to be
checked.
 Unplug the saw.
 Raise the blade.
 Remove the blade guard assembly.
If the blade is not perfectly vertical (0°):
 Loosen the adjustment screw and the bevel locking lever.
 Place a combination square beside the blade on the left.
Lock the angle by pushing the bevel locking lever down
and retighten the adjustment screw.
 Turn the handle until the bevel indicator points to zero.
If the handle is turned as far as possible and doesn't
indicate zero properly, you may need to adjust the bevel
indicator.
NOTE: It will be necessary to remove the handle to adjust
the bevel indicator.
If the blade is not an exact 45°:
 Loosen the adjustment screw and the bevel locking lever.
 Place a combination square beside the blade on the left.
 Turn the handle until the bottom of the blade has moved
completely to the left side of the slot. Lock the angle by
pushing the bevel locking lever.
 If the blade is not an exact 45°, loosen the 45° adjustment
screw and the bevel locking lever.
 Adjust the bevel indicator to 45°.
 Make a test cut.
All manuals and user guides at all-guides.com
ADJUSTMENTS
36 - English
0° ADJUSTMENT
SCREW
BEVEL BLADE
HANDLE
0°
BEVEL
INDICATOR
BLADE
45°
BEVEL
LOCKING
LEVER
BEVEL
HANDLE
45° ADJUSTMENT
SCREW
Fig. 45
COMBINATION
SQUARE
BEVEL
LOCKING
LEVER
Fig. 46
COMBINATION
SQUARE
BEVEL
INDICATOR
Fig. 47