Water Filter - GE Profile 42 Série Manuel D'utilisation

About the water filter cartridge.
Water filter cartridge
The water filter cartridge is located behind the upper cover
at the top of the refrigerator.
When to replace the filter on models with a replacement
indicator light
There is a replacement indicator light for the water filter
cartridge on the dispenser. This light will turn orange to tell
you that you need to replace the filter soon.
The filter cartridge should be replaced when the
replacement indicator light turns red or if the flow of water
to the dispenser or icemaker decreases.
Removing the filter cartridge
If you are replacing the cartridge, first remove the old one
by slowly turning it to the left. Do not pull down on the
cartridge. A small amount of water may drip down.
NOTE: To reduce the risk associated with property damage
due to water leakage, read and follow instructions before
installation and use of this system. Installation and use MUST
comply with all state and local plumbing codes.
WARNING
To reduce the risk associated with choking, do not allow children under 3 years of age to have access to small parts
during the installation of this product. The disposable filter cartridge should be replaced every 6 months at the rated
capacity, or sooner if noticeable reduction in flow rate occurs.
For the maximum benefit of your filtration system, GE recommends the use of GE-branded filters only. Using GE-branded
filters in GE and Hotpoint refrigerators provides optimal performance and reliability. GE filters meet rigorous industry NSF
standards for safety and quality that are important for products that are filtering your water. GE has not qualifed non-GE
branded filters for use in GE and Hotpoint refrigerators and there is no assurance that non-GE branded filters meet GE's
standards for quality, performance and reliability.
If you have questions, or to order additional filter cartridges, visit our website at www.gewaterfilters.com or call GE
Parts and Acessories, 800.626.2002.
Customers in Canada should consult the yellow pages for the nearest Camco Service Center.
8
(On some models.)
Installing the filter cartridge
Fill the replacement cartridge with water from the tap
1
to allow for better flow from the dispenser immediately
after installation.
Line up the arrow on the cartridge and the cartridge
2
holder. Place the top of the new cartridge up inside the
holder. Do not push it up into the holder.
Slowly turn it to the right until
3
the filter cartridge stops. DO NOT
OVERTIGHTEN. As you turn the
cartridge it will automatically raise
itself into position. cartridge will
move about a 1/2 turn.
Run water from the dispenser for
4
1-1/2 gallons (about three minutes) to clear the system
and prevent sputtering.
Press and hold the RESET WATER FILTER pad (on some
5
models) on the dispenser for three seconds.
NOTE: A newly installed water filter cartridge may cause
water to spurt from the dispenser.
Filter bypass plug
You must use the filter bypass plug when a
replacement filter cartridge is not available.
The dispenser and the icemaker will not
operate without the filter or filter bypass
plug.
Cartridge
Holder
Filter
Bypass
Plug