Replacing The Lamp - AEG SCS41800S0 Notice D'utilisation

REPLACING THE LAMP

CLOSING THE DOOR
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
All manuals and user guides at all-guides.com
1. Disconnect the mains plug from the
mains socket.
2. Remove the screw from the lamp
cover.
3. Remove the lamp cover (refer to
the illustration).
4. Replace the used lamp with a new
lamp of the same power and spe-
cifically designed for household ap-
pliances. (the maximum power is
shown on the lamp cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cov-
er.
7. Connect the mains plug to the
mains socket.
8. Open the door. Make sure that the
lamp comes on.
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH
45