Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Timer
There are two ways to use the timer:
– as a safety cut-out function. Set a cooking period for a cooking
zone, and after this time has elapsed the cooking zone will automati-
cally switch itself off. This function can be used for more than one
cooking zone simultaneously.
– as a countdown timer without a cut-out function ("egg timer"),
whereby an acoustic signal can be heard after the set period of time
has elapsed.
3
The countdown timer cannot be used if a cooking zone is switched on.
Safety cut-out
The cooking zone(s) for which you want to use the safety cut-out func-
tion must be switched on.
1. Using the timer sensor panel, select the cooking zone for which the
safety cut-out is to be set.
By touching the timer sensor panel once the first active cooking zone is
selected in a clockwise direction, and the corresponding control lamp
will flash rapidly. Hereby the (e.g.) left rear control lamp corresponds to
the left rear cooking zone. 00 will appear in the timer display.
The next active cooking zone is selected by touching the timer sensor
panel again.
2. While the control lamp is flashing rapidly, use the + or - timersetting
sensor panels to set the desired period of time for this cooking zone up
until the point where it automatically switches itself off (e.g.
15 minutes).
All manuals and user guides at all-guides.com
17
Publicité
Table des Matières
