Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENG LIS H
M. BACKRESTS AND BACK UPHOLSTERY
1. Backrest/Stroller Handles
Quickie 2 wheelchairs with depth adjustable backs are shipped with the backrest/stroller handles (A) in a
folded position. To secure backrest/stroller handles, lift backrest/stroller handles to upright position. When
secured, backrest release pin will lock into place.
2. Backrest Upholstery
a. Check monthly for excessive stretching of the upholstery, or loose attaching hardware. If you deter-
mine the upholstery is no longer tight, contact your service representative for a replacement.
3. Solid Back Insert
Place the solid back hook clamps (B) on the stroller handles (A). Insert the quick release pins (C) through the
mounting holes on the top two hook clamps.
N. SWING-AWAY ADJUSTABLE STROLLER HANDLES
5. Positioning Swing-Away Adjustable Stroller Handles
Loosen push handle (D) by turning knob (E) counter-clockwise. Raise or lower push handle (A) to desired
height. While holding push handle (D) in one hand, raise retaining ring (F) with knob (E) upward into locking
slot with other hand.
NOTE:
Locking slot is hidden under retaining ring . When knob is raised into locking slot (D) push handle
cannot rotate. Dropping into lower slot ( E ) allows push handle to swing in. To secure push han-
dle, turn knob clockwise.
NOTE:
For easy storage and portability, push handles will swing in and stroller handles fold flat.
O. SEATING AND SEAT SLING UPHOLSTERY
The seat sling can be adjusted through the use of hook and loop material beneath the seat. Seat sling also
includes a folding strap on the seat to assist in folding the chair.
NOTE–
The seat sling folding strap is not intended as a carrying strap.
1. Adjustment
a. Remove seat rail end caps at the front of the chair (F).
b. Slide the seat sling, plastic retaining rods, and spacers (if present) from the channels in the seat rails.
c. Readjust hook and loop material to obtain the desired tension in the seat sling.
d. Reinsert the seat sling and plastic retaining rods into the channels in the seat rails.
e. Replace the end caps.
2. Seat sling Upholstery
a. Check monthly for excessive stretching of the upholstery, or loose attaching hardware. If you deter-
mine the upholstery can no longer be adjusted tight, contact your service representative for a replace-
ment.
3. Cushion Installation
a. Place cushion on the seat sling with hook material side down. The beveled edge of the cushion should
be facing toward the front of your chair.
b. Press firmly into place.
MK-100070 RevA
All manuals and user guides at all-guides.com
24
25
26
(option)
27
18
VIII. USE AND MAINTENANCE
24
25
26
27
Publicité
Chapitres
Table des Matières
Dépannage
