Controlling The Suction Level; Vacuuming With Accessories; After Vacuuming - Bosch Relyy'y BGC3 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 55
7
Fig.
Holding the power cord by the plug, pull it out to the
required length and insert the plug into the mains
socket.
8
Fig.
To switch the vacuum cleaner on or off, press the
ON/OFF button.

Controlling the suction level

9
Fig.
Turn the control knob to infinitely adjust the suction
level to the level required.
„ Low power range
= For vacuuming delicate materials, e.g. delicate
>
upholstery, curtains, etc.
„ Medium power range
= For daily vacuuming of lightly soiled floors.
>
„ High power range
= For vacuuming durable floor coverings, hard floors
>
and heavily soiled surfaces.
Vacuuming
!
Caution
Floor nozzles are subject to a certain amount of
wear, depending on the type of hard floors you have
(e.g. rough, rustic tiles). You must therefore check
the underside of the floor nozzle at regular intervals.
Worn undersides of floor nozzles may have sharp
edges that can damage sensitive hard floors, such as
parquet or linoleum. The manufacturer does not ac-
cept any responsibility for damage caused by worn
floor nozzles.
10
Fig.
Set the adjustable floor nozzle:
„ Rugs and carpets =>
„ Hard floors/parquet =>
If you are vacuuming up relatively large particles, make
sure that you vacuum them up successively and careful-
ly to ensure that the vacuum channel of the floor nozzle
does not become blocked.
If necessary, you should raise the nozzle in order to
better vacuum up the dirt particles.

Vacuuming with accessories

11*
Fig.
Attach the nozzles to the suction pipe or handle as re-
quired:
a) Crevice nozzle for vacuuming crevices and corners,
etc.
b) Upholstery nozzle for vacuuming upholstered furni-
ture, curtains, etc.
c) Upholstery nozzle with fixed brush ring for vacu-
uming window frames, cupboards, profiles, etc.
After use, reinsert the crevice nozzle and upholstery
nozzle into the accessories holder.
All manuals and user guides at all-guides.com
d) Professional crevice nozzle
e) Professional upholstery nozzle
f) Hard-floor nozzle for vacuuming hard floor coverings
Cleaning the hard-floor nozzle
Fig.
a) Vacuum the nozzle from below to clean it.
b) Use scissors to cut through threads and hairs wound
Drill dust nozzle
Fig.
a) Fasten the drill dust nozzle onto the handle and
b) Set the appliance to the lowest power level and
c) The drill dust nozzle is held in the required position
Fig.
You can use the parking aid on the back of the vacuum
cleaner if you want to stop vacuuming for a short time.
Fig.
When vacuuming stairs, the appliance must be positi-
oned at the bottom of the stairs. If it does not reach
far enough, the appliance can also be carried using the
carrying handle or the handle on the dust container.

After vacuuming

Fig.
Fig.
Fig.
To store the appliance, use the storage aid on the un-
derside.
a) Prop up the appliance with the hose or dust contai-
b) Slide the hook on the floor nozzle into the storage
* Dependent on model
Extra-long crevice nozzle for cleaning crevices, cor-
ners and narrow spaces, e.g. in a car.
For gently and thoroughly cleaning upholstered fur-
niture, curtains, etc.
For cleaning the professional upholstery nozzle, sim-
ply vacuum it using the handle.
(tiles, parquet flooring, etc.)
12*
round the rollers and then vacuum them away.
13*
position it on the wall so that the drill hole opening
on the nozzle is placed directly over where the hole
is to be drilled.
then switch it on.
by suction. Depending on the condition of the wall
to be drilled, you may need to adjust to a higher
power setting to ensure that the drill dust nozzle
remains in place.
During drilling, the fine dust is automatically vacu-
umed up.
14
After switching off the appliance, slide the hook on
the floor nozzle into the parking aid.
15
16
Switch off the appliance.
Remove the main plug.
Briefly pull on the power cord and then let go.
(The power cord retracts automatically.)
17*
Unlock the telescopic tube by moving the sliding
switch in the direction of the arrow, and slide one
tube into the other.
18
ner handle.
aid.
45

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Relyy'y bgs3

Table des Matières