Care & Cleaning Instructions; Steps For Stain Removal And Proper Care Of Your Non-Stick Coating; Storing Instructions - Bella 12 x 12 Manuel D'instructions

Care & Cleaning Instructions
CAUTION: Do not immerse the cord, plug or temperature control probe in water or any other liquid.
CAUTION: To avoid accidental burns, allow your Electric Skillet to cool thoroughly before cleaning.
1. When cooking is completed, unplug cord from wall outlet. Allow Electric Skillet to cool.
2. Remove temperature control probe from Electric Skillet.
CAUTION: The probe may become hot after use. Allow to cool before handling.
3. If necessary, wipe temperature control case and probe with a damp, soft cloth. Dry temperature
control probe completely. Set aside.
CAUTION: The temperature control probe is not immersible.
4. The skillet base is NOT dishwasher safe. You can wash it with warm soapy water and rinse it dry
after each use. All parts except the temperature control probe are fully immersible.
NOTE: Only the SKILLET LID is top rack dishwasher safe.
5. To wash by hand, immerse Electric Skillet and glass lid in hot, sudsy water. Clean thoroughly using
a sponge or soft cloth. Rinse in hot water. Dry completely.
6. For stubborn food particles, loosen with a plastic cleaning pad. Avoid hard scouring of the non-stick
finish as this may cause surface scratches. Do not use steel wool, scouring pads, or abrasive
cleaners on any part of the Electric Skillet.
7. For best results and preserve the non-stick coating longer, use nylon, plastic, wooden or rubber
utensils. Never cut food on the cooking surface.

Steps for stain removal and proper care of your Non-Stick coating

1. Identify stained areas on the cooking surface and sprinkle some baking soda on the stains.
2. Moisten the baking soda to get a paste like texture by adding some water.
3. Let the paste stand for a few minutes on the stains (not more than an hour)
4. Rub with a soft damp cloth or lightly scrub with a plastic scouring pad, wipe clean and dry
thoroughly.
NOTE: Do not rub vigorously when using a plastic scouring pad and NEVER use a metal scouring
pad as this may damage the non-stick coating.
5. Repeat the cycle once again if necessary. The performance and non-stick property of the non-stick
coating will not be affected due to stains

Storing Instructions

1. Unplug unit and allow to cool. Never store the Electric Skillet while it is hot or still plugged in.
2. Clean the Electric Skillet thoroughly before storing.
3. To avoid scratching the non-stick surface, first place a paper towel into the skillet.
Store the temperature control probe inside the covered Electric Skillet.
4. Store the clean Electric Skillet in its box or in a clean, dry place.
8