Using The Harness System - JANE nurse SWING Instructions

GB
sWING
The safety seat should only be used in the forward facing position if:
* The child measures > 76 cm.
* The child is at least 15 months old. It is advisable to use the safety seat in the rear facing position for
as long as possible.
* The headrest covers the indicator when it is correctly adjusted.
* The headrest is set to level 7 or higher.
9 360° ROTATION
The safety seat can be rotated 360° to make it easier to get the child in and out of the vehicle. This also
allows you to change the seat from the rear facing position to the forward facing position.
* Press the rotation button (14) to turn the seat frame towards the car door so you can fasten the child
in easily. See chapter: USING THE HARNESS SYSTEM.
The frame will click when it locks into place.
NOTE! Before staring your car journey, make sure the seat frame is locked into the correct position by
pressing the position adjustment lever.
* If the indicator displays a green arrow, the seat is not locked into place. Repeat the process if necessary.
NOTE! make sure that the seat frame is correctly locked into place. To do this, try to rotate it without
pressing the position adjustment lever.
NOTE! Make sure that no dirt or sands gets between the upper frame of the seat (13) and the base(15),
as this could adversely affect the performance of the rotation and reclining function. If this happens,
remove the dirt before turning or reclining the seat to prevent any permanent damage.
WARNING! On car journeys the seat must always be locked into the rear facing or forward facing
position. Never use the seat locked in the sideways position or in any intermediate unlocked position
while travelling.
10

USING THE HARNESS SYSTEM

The shoulder straps are firmly attached to the headrest and should not be adjusted separately.
NOTE! Make sure that the headrest is correctly locked into place before using the safety seat.
NOTE! Make sure that the safety seat does not have any hard toys or objects caught in it.
* Loosen the shoulder straps by pressing the adjustment button (16) on the central adjuster and
simultaneously pulling both shoulder straps (17) upwards.
NOTE! Always pull the shoulder straps and not the shoulder pads.
* Unfasten the harness (20) by firmly pressing the red button (18).
NOTE! Make sure that the shoulder straps are not twisted.
24