JANE nurse SWING Instructions page 23

GB
sWING
5 FITTING THE SUPPORT LEG
Make sure that the support leg 1 is fixed in the forward position. Press the support leg switches 8
simultaneously to pull the support leg. Pull out the support leg until it safely stands on the vehicle
floor. Press the support leg adjustment buttons 9 and Pull the support leg to the next locking position
to ensure optimal force absorption. Please ensure that the support leg indicator 10 shows green.
WARNING! The support leg must always have direct contact with the ground. It is not allowed to place
objects under the support leg.For information on the storage compartments in the foot area please
contact your vehicle manufacturer. NOTE! Make sure that this l-Size still rests flat on the car seat.
REMOVING THE SEAT FROM THE VEHICLE
6
To remove the safety seat follow the installation procedure in reverse.
Unlock the ISOFIX connectors (3) on both sides by pressing the release buttons (4) and simultaneously
removing the seat. Push the ISOFIX extension strap (8A) found underneath the body of the safety seat
and set both ISOFIX connectors (3) to the short position.
Take the safety seat out of the ISOFIX anchor points. Return the ISOFIX connectors (3) to their original
position. Press the button on the support leg upwards and press it to push the support leg back to its
original position. Fold the support leg (1) back under the base.
7 ADJUSTING THE RECLINING POSITION
Backrest position label
This i-Size safety seat has 3 different sitting and reclining positions for your child to travel in the car
comfortably and safely. If you want to change the position, use the adjustment lever (11) on the front
part of the safety seat to set the seat to the required reclining position.
WARNING! Always make sure that the position adjustment lever is locked into the sitting or lying down
position. Do not lock it into the transverse position.
*The rearward face is only blue color position available ,three red position is available to forward face.
8
USING THE SEAT IN THE REAR FACING POSITION (PART 2) (40-105cm)
Headrest adjuster (13)
NOTE! The insert for newborn babies helps to protect your child. It should be used until the child
measures 60 cm.
NOTE! The headrest only guarantees the best possible protection for your child if it is set to the right
height. There are 12 different height positions to choose from.
The headrest should be adjusted so that there is minimal space between the child's shoulders and
the headrest.
* Use the adjuster ring (12) on the top of the headrest to move the headrest to the required position.
NOTE! The shoulder straps are firmly attached to the headrest and do not need to be adjusted
separately.
NOTE! The safety seat can be used in the rear facing position until the child measures 105 cm.
23