Stihl HS 45 Notice D'emploi page 6

English
Refueling
Gasoline is an extremely
flammable fuel. Keep
clear of naked flames. Do
not spill any fuel – do not
smoke.
Always shut off the engine before
refueling.
Do not fuel a hot engine – fuel may spill
and cause a fire.
Open the fuel cap carefully to allow any
pressure build-up in the tank to release
slowly and avoid fuel spillage.
Only refuel the machine in a well
ventilated place. If fuel has been spilled,
immediately clean the machine – do not
allow your clothes to be splashed with
fuel. If that happens, change your
clothes at once.
The power tools may be fitted as
standard with different fuel caps.
After fueling, tighten
down the screw-type fuel
cap as securely as
possible.
Place the clip lock fuel
cap (bayonet-type) in
position, turn it until it will
go no further and fold the
clip lock down.
This helps reduce the risk of unit
vibrations causing an incorrectly
tightened fuel cap to loosen or come off
and spill quantities of fuel.
Check for leaks. Do not start the engine
if there is a fuel leak – serious or fatal
burns could result!
4
Before starting
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the User
Manual:
Check the fuel system for leaks,
–
especially the visible parts, e. g.,
fuel cap, hose connections, manual
fuel pump (only in machines with a
manual fuel pump). In case of
leakage and damage, do not start
the engine – risk of fire! Have the
machine serviced by a dealer
before using it
Insert the blade lock (if fitted)
–
Slide control / stop switch must
–
move easily to STOP or 0
Smooth action of throttle trigger
–
lockout and throttle trigger – the
throttle trigger must return
automatically to the idle position
Check that the spark plug boot is
–
secure – a loose boot may cause
sparking that could ignite
combustible fumes and cause a fire!
Cutting blades must be properly
–
tightened and in safe operating
condition (clean, sharp, not bent or
warped), correctly mounted and
thoroughly sprayed with STIHL
resin solvent (lubricant)
Check cutter guard (if fitted) for
–
damage
Never attempt to modify the controls
–
or safety devices
Keep the handles dry and clean –
–
free from oil and dirt – this is
important for safe control of the
machine
To reduce the risk of personal injury, do
not operate your power tool if it is
damaged or not properly assembled!
Starting the engine
Start the engine at least 3 meters from
the fueling spot, outdoors only.
Place the power tool on firm ground in
an open area. Make sure you have good
balance and secure footing. Hold the
power tool securely. The cutting blades
must be clear of the ground and all other
obstructions because they may begin to
run when the engine starts.
Your power tool is designed to be
operated by one person only. Do not
allow other persons in the work area –
even when starting.
Avoid contact with the cutting blades –
risk of injury!
Do not drop-start the engine – start it as
described in the User Manual.
Note that the cutting blades continue to
run for a short period after you let go of
the throttle trigger - flywheel effect!
Check engine idling: The cutting blades
must remain at a standstill when the
engine idles – throttle trigger released.
HS 45